My three inch topper came ups and there is a rip a few inches long and half thru the thickness on the edge in one place and another about an inch long on the other side in the center area edge. I would imagine I should glue these? There is also a small chunk missing inbetween the  holes left by the machine. Not affecting function but is this normal for latex toppers to come with rips like this?  My old memory foam never ripped till it was old.

  What is a good glue to use? I don't want it to spread

I contacted several latex vendors a while back with this question, and they had no suggestions. The only adhesives I found that were specifically recommended for foam latex were Misty Foam and Fabric Adhesive and Camie 303. But I never got around to trying either.

I would be hesitant to use one specified for just "foam" since latex foam is very different from PU.

BobKat wrote:  What is a good glue to use? I don't want it to spread

i used this product it is the best i have used so far it holds great and doesnt make a mess

hope this helps

3M™ Rubber & Vinyl 80 Spray Adhesive

Thanks :)